and again after the glass is cut out to minimize contamination. 3. Cut into existing ... of urethane, make sure there is a MINI- MUM of 1/4 inch of glass, in addition ... the glass. Mark location by apply- ing masking tape to windshield and car body. Slit ... 14. Position the glass by aligning the masking tape on glass and car body. Press glass ... and car body to fill voids. 16. Remove masking tape alignment strips. 17. Replace ... and again after the glass is cut out to minimize contamination. 3. Cut into existing ... of urethane, make sure there is a MINIMUM of 1/4 inch of glass, in addition to ... of the glass. Mark location by applying masking tape to windshield and car body. Slit ...
14. Position the glass by aligning the masking tape on glass and car body. Press glass ... and car body to fill voids. 16. Remove masking tape alignment strips. 17. Replace ... and again after the glass is cut out to minimize contamination. 3. Cut into existing ... of urethane, make sure there is a MINI- MUM of 1/4 inch of glass, in addition ... the glass. Mark location by apply- ing masking tape to windshield and car body. Slit ... 13. Position the glass by aligning the masking tape on glass and car body. Press glass ... and car body to fill voids. 15. Remove masking tape alignment strips. 16. Replace ...
