Catalog: Classic Pontiac GTO Catalog | |
| inner door panels. Panel boards are die-cut and have all holes and perforations of ... | |
| 2: A147M can be used on convertibles by cutting out a small section for the door jamb ... A147AL are low-pressure castings die-cast unavailable. Quality is still good. ... | |
| are ready for installation. They are die-cut and come with the vinyl strip and foam ... | |
| . Comments:Very good. The filler is die-cut for proper fit. Originals had the hair ... | |
| we were able to locate and transfer all dies in order to use original GM tooling for ... on most cars. This plastic baffle is die-cut using original specifications ... | |
| that is now too tall. It must be cut for your specific application (actual ... the underhood bracing will need to be cut to accept Ram Air components. Note 2: ... inside of the front brace has two small cutouts that were not on original hoods. Once ... the underhood bracing will need to be cut. Instruction sheet available upon ... 22.00/ea. These emblems are die-cast to all original specifications ... | |
| underhood insulation pads are die-cut from a charcoal gray material that is ... | |
| 5.50/set These gaskets are die-cut from .043" rubber like originals. Set ... | |
| RE)......... 99.00/ea. Boot material is die-cut and stitched like original. Vinyl is ... | |
| 22.00/ea. K105T and K106J are a die-cut, rubber backed green-gray felt material ... | |
| . Note: These foam Ram Air seals are die-cut to replace your original deteriorated ... | |
| from water, mud, snow, etc. They are die-cut from .065" masticated rubber like ... | |
