Page 57 of Classic Pontiac GTO Catalog by Ames Performance Engineering

1-800-421-2637 57 D116 D117B D118 Cross-SectionView D116 1964-67 Hood to Cowl Seal (RE)........................... $10.00/ea. D117 1968-70 Hood to Cowl Seal w/Plastic Clips (A-body) (RE)............................................. 12.00/ea. D117B 1968-77 Hood to Cowl SMetal Clip (RE) .............. Inquire D117D 1971-74 Hood to Cowl Seal (X-body) (GM) ......... 7.00/ea. D116 through D117D are the weatherstrips that seal between the rear of the hood and the top of the firewall. D118 1964-67 Cowl Top Vent to Cowl Seal (RE)............. 10.00/pr. These are the foam rubber seals located under the cowl in front of the windshield. D118C Lower Cowl Drain Plugs (RE).................. 3.00/ea. These plugs are for the 1 hole located in the lower front section of the cowl. COWL SCREENS GRILLES COWL COMPONENTS D119 1968-69 Cowl Screen (RE)...................................... 20.00/ea. D119 is made from the correct wire mesh. D119B 1968-69 Cowl Screen Bolt Kit (RE) ....................... 6.00/kit D120 D123 D120 1970-72 Cowl Grille 3 Pcs. (A-body) (RE)........... 20.00/set Note: These reproductions are made to replace your old broken or missing grilles. Cowl grilles are molded from a heat resistant material to resist distortion. These grilles are used on cars with or without air conditioning. Comments: Quality is excellent. D123 1964-72 Upper Cowl Drain Plug (RE) ................... .50/ea. Note: These are the 1/2 plastic plugs located at the top outer corners of the cowl.2 required per car. HOOD HINGE COMPONENTS D130 1964-67 Hood Hinge Spring (GM)........................ 16.00/ea. D131 1968-73 Hood Hinge Spring (A-body) (GM) (RP). Inquire D131 1971-74 Hood Hinge Spring (X-body) (GM) (RP). Inquire D134AN D134C D134AN 1964-66 Hood Stud Bolt (RE)................................. 2.50/ea. 4 required per car. D134B 1964-66 Hood Hinge Nut and Bolt Kit (RP).......... 4.50/kit D134C 1967-77 Hood Hinge Bolt Kit (RP) ........................ 4.50/kit Correct Rivet Design D132L 1964-67 Hood Hinge, LH (A-Body) (APE)............. $75.00/ea. D132R 1964-67 Hood Hinge, RH (A-Body) (APE)............ 75.00/ea D133L 1968-72 Hood Hinge, LH (A-Body) (APE)............. 75.00/ea D133R 1968-72 Hood Hinge, RH (A-Body) (APE)............ 75.00/ea Note: After 5 years of testing we met our quality standards. Customers no longer must concern themselves with weak poorly headed rivets or weak arms resulting in costly failures. This testing has resulted in the following advantages of the Ames Performance hinge: 1) Complete chemical hardness analysis of hinge steel. 2) Rivet composition upgraded to W1 tool steel. 3) Rivet design and heading procedure same as GM. 4) Hinge arms hardened. 5) Prototypes cycled over 2000 repetitions without failure. 6) Steel surface similar to original gray phosphate. D133S 1964-67 Hood Hinges, Pair (A-Body) (APE) .......... 148.00/pr. D133T 1968-72 Hood Hinges, Pair (A-Body) (APE) .......... 148.00/pr. D134 1971-77 Hood Pop Up Spring (A-body) (RE) ........ 11.00/ea. HOOD TACHS D142 D141 1967 Hood Tach, W/Harness (RE) .................... 210.00/ea. D142 1968 to Early 69 Hood Tach W/Harness-5100 Redline (RE) 210.00/ea. D142K 1968 to Early 69 Hood Tach W/Harness-5500 Redline (RE) 210.00/ea. D143 Late 1969-72 Hood Tach W/Harness-5100 Redline (RE) 210.00/ea. Hood tachs continue on next page.

[close]