Selected page of Brad Porcellato's 2005 Club Car Parts Catalog
PART NUMBER DESCRIPTION CROSS REFERENCE
101692501
COWL, FRONT, BEIGE, 93-03
$291.43
Injection molded polymer.
Used on Club Car gas and electric,
93-03. Custom colors extra. Call.
101692601
BODY, REAR, GAS, BEIGE, 93-03
$488.50
Injection molded polymer.
Used on Club Car gas,
93-03. Custom colors extra. Call.
101693301
BODY, REAR, ELEC, BEIGE, 93-03
$488.50
Injection molded polymer.
Used on Club Car electric,
93-03. Custom colors extra. Call.
1017083-01
CUP HOLDER, DUAL, 93-UP
$18.42
Dual cup holder with 4 tee holders.
Injection molded of black HDPE.
Used on Club Car gas and electric,
93-UP.
1013422
CUP HOLDER, SINGLE, 81-94
$16.66
Injection molded single cup holder.
Used on Club Car gas and electric,
81-94.
1013649
DC RECEPTACLE BEZEL, 85-UP
$5.53
Molded of black ABS. Has rectangle
recepticle hole. Used with P/N 66036
-72 2 prong, DC receptacle.
Used on Club Car (36 volt), 85-UP.
1015032
FLOOR MAT, 81-UP
$82.30
Die cut rubber with pebble texture
| PART NUMBER DESCRIPTION CROSS REFERENCE
101816301
SPRING KIT, BRAKE, 00-UP
$23.94
Includes upper and lower tension
spings, adjuster spring, two cup and
spring assemblies and two retainer
pins.
Used on Club Car gas electric, 00-
UP; EZ-Go gas and electric, 97-UP;
Yamaha Gas and electric, 93-UP
(G14, G16, G19)
1013531
SPRING, BRAKE RETURN
$6.56
15 coil tension spring. Measures
approximately 2-1/2" long.
Used on Club Car gas electric 99-
UP and Club Car electric, 88-98.
101933001
SPRING, BRAKE RETURN, 87-98
$11.91
Tension-type, twenty-coil spring.
Measures approximately 3-7/8" L.
Used on Club Car gas,
87-98.
1011466
SPRING, BRAKE SHOE
$28.06
"U Shaped" spring steel retainer
for brake shoes.
Used on Club Car gas and electric,
81-UP; EZ-Go gas and electric, 81-96;
Yamaha gas and electric, 78-91 (G1,
G2, G8, G9)
1011464
SPRING, BRAKE SHOE, 80-UP
$33.15 (Package of 4)
17-Coil spring. Measures approxi
mately 3-3/4"L.
Used on Club Car gas electric,
80-UP
| PART NUMBER DESCRIPTION CROSS REFERENCE
1017530-05
F R SWITCH 48V,PWR DRIVE, 96-UP
$85.66
Complete switch, less handle.
Includes 3 micro switches and
installation instructions.
Used on ClubCar electric,
(Power Drive). 96-UP
1018560-01
F R SWITCH, POWERDRIVE+ 98-UP
$21.05
Plastic "snap-in" switch with rockertype selector and six male spade
terminals.
Used on ClubCar electric,
(Power Drive+). 98-UP
1018021-01
FUSE RECEPTACLE KIT, 95-UP
$72.78
Injection molded black plastic
receptacle housing with 3-prong
female plug. Includes mounted clear
plastic covered fuse link, moisture
resistant inline fuse holder, 3/8-amp
type AGC in-line fuseand installation
instructions.
Used on ClubCar 48-volt electric,
95-UP.
1014516
FUSE ASSEMBLY, 36-VOLT, 85-UP
$8.51
Assembly for 36-volt systems.
Includes P/N 1012085 fuse, P/N 1012142
base and P/N 1012143 clear lens.
Used on ClubCar 36-volt electric,
85-UP.
1012531
KEY SWITCH, ELECTRIC, 84-95
$34.20
Switch includes P/N
| PART NUMBER DESCRIPTION CROSS REFERENCE
1012422
VOLTAGE REGULATOR, 84-91
$62.85
For use with Hitachi-style starter
generator.Used on Club Car gas, 84-
91; Columbia/Harley 2-cycle gas, late
76-84; EZ-Go 2-cycle gas, 80-UP;
Hyundai gas, 91-UP; Yamaha gas, 78-
91 (G1, G2, G9).
1013887
WIPER ARM/CARRIER, SPD SWITCH
$5.79
Injection molded housing with shaft
and holder for the wiper brush.
Used on Club Car electric with V-
Glide,
88-UP.
1014290
BELT, GENERATOR, 88-91 and '94
$13.59
Reinforced belt. Measures
approximately 3/8" W x 32-3/4" O.D.
Used on Club Car gas 88-91 and '94.
1015241
BELT, GENERATOR, 92-93, 95-96
$11.58
Reinforced belt. Measures
approximately 3/8" W x 32-3/4" O.D.
Used on Club Car gas 92-93 and 95-
96.
1012974
CARB REPAIR KIT, 84-91
$91.25
Kit includes: float bowl o-ring, mani
fold gasket, pilot jet, main jet, pilot
screws and spring, idle stop screw and
spring, main nozzle, needle valve
gasket, float bowl retaining nut and
gasket.
U
| PART NUMBER DESCRIPTION CROSS REFERENCE
1017434
GASKET, HEAD, 96-UP, FE350
$24.85
Stamped aluminum "crush-type"
gasket.
Used on Club Car gas FE350,
96-UP.
1012511
GASKET, HEAD, 84-91
$49.86
Composition material gasket pressed
between aluminum jackets.
Used on Club Car gas, KF82 (341cc),
84-91.
1016430
GASKET, HEAD, 92-UP
$14.89
Stamped aluminum "crush-type"
gasket.
Used on Club Car gas, FE290,
92-UP.
1016439
GASKET, INSULATOR, 92-UP
$1.54
Die-cut gasket. Measures approxi
mately 1-3/4" between mount hole
centers.
Used on Club Car gas,
92-UP
1016440
GASKET, INTAKE, 92-UP
$1.49
Die-cut gasket, measures approxi
mately 1-3/16" between mount hole
centers.
Used on Club Car gas FE290
FE350,92-UP.
1013952
GASKET, PUMP COVER, 84-91
$1.80
Die-cut gasket for impulse pump.
Measures approximately 1-25/32"
between mount hole centers.
Used on Club Car gas,
84-91.
1016436
GASKET, ROCKER COVER, 92-UP
$10.41
Molded black neoprene gasket.
Used on Club Car
| PART NUMBER DESCRIPTION CROSS REFERENCE
1013474B-25
REBUILD KIT, .25MM, 86-91
$call
Includes .25mm piston, rings, piston
pin with retainers, valves, bearings,
connecting rod, crankshaft assembly
and gasket set.
Used on Club Car gas, 86-91.
1013474B-50
REBUILD KIT, .50MM, 86-91.
$call
Same as 1013474B-25 except with
.50MM piston.
1012516
RING SET, STD, 84-91
$39.86
Three ring set.
Used on Club Car gas, (KF82 341cc).
Tips: Before installing rings on piston,
always check to insure you have the
proper end gap clearance when the
rings are inserted in the cylinder.
Consult the Club Car serice manual
for specifications and complete
installation instructions.
1012960
RING SET, .25MM, 84-91
$call
Three ring set.
1012961
RING SET, .50MM, 84-91
$call
Three ring set.
PART NUMBER DESCRIPTION CROSS REFERENCE
1016461-01
RING SET, STD, FE290, 92-UP
$42.44
Set consists of two compression rings
and a three-piece oil ring.
Used on Club Car gas, (FE290).
92-UP.
Ti
| PART NUMBER DESCRIPTION CROSS REFERENCE
1013778
BEARING, 84-UP.
$call
Ball bearing, open both sides.
Measures approximately 1.57" I.D.
x 2.68" O.D. x .580"
Used on Club Car electric, 84-UP;
Cushman; EZ-Go 4 cycle gas, 91-UP;
Noland; Pargo; Yamaha electric, 79-82
(G1, G2, G8 1992 and earlier, G9).
1011291
BEARING, 84-UP.
$12.12
Ball bearing, sealed both sides.
Measures approximately .980" I.D.
x 2.05" O.D. x .590"
Used on Club Car gas, 84-UP and
electric, 84-86 (inner rear axle);
Columbia/Harley gas and electric,
96-00 (rear axle) and 2-cycle gas,
82-95; Cushman (differential); EZ-Go;
Noland; Nordskog; Pargo; Taylor Dunn;
Yamaha 4cycle gas, 85-95 (input shaft)
and electric, 81-92 (input shaft).
1011694
BEARING, ACCELERATOR, 81-UP
$19.62
Brass alloy bushing pressed into a
steel sleeve and then pressed into an
aluminum mounting bracket. Bushing
measures approximately .50" I.D.
Mount plate bracket has four drilled
mounting holes.
Used on Club Car gas and e
| PART NUMBER DESCRIPTION CROSS REFERENCE
1010142K-612
SHOCK BUSHING KIT,
$4.10
For most 3/8-24 threaded stud mount
shock absorbers. Kit includes rubber
bushings (2), retainer washer (2) and
3/8-24 hex pal nut (1). Kit is good for
one shock.
Used on Club Car,
All years.
1014235
SHOCK, FRONT, 81-UP
$25.40
Bushing mount both ends. Compresses
to 9-5/8"; extends to 11-3/8", measured
end to end.
Used on Club Car gas and electric,
81-UP.
1014236
SHOCK, REAR, 81-UP
$25.40
Threaded 3/8-24 shaft both ends.
Compresses to 11-1/2"; extends to
14-1/2", measured from ends of shafts.
Used on Club Car electric,
81-UP.
1014234
SHOCK, REAR, 84-96
$24.52
Bushing mount on one end; threaded
3/8-24 shaft on the other. Compresses
to 10-1/4"; extends to 13-1/4",
measured from end to end.
Used on Club Car gas, 84-96; EZ-GO
electric, 79-94 (3 and 4 wheel).
1010348
SPINDLE, DRIVER SIDE, 81-UP
$107.70
Spindle assembly with bronze bushing.
Used on Club Car gas and electric,
8
| ATTICA EQUIPMENT LTD. 150 GLACIER ST. MAYFAIR INDUSTRIAL PARK, COQUITLAM, B.C. V3K 5Z6
Call Brad Porcellato, PH. 604 941-9608 FAX. 604 941-2158 CEL. 604 418-5682 HOME. 604 525-4870
OPTIONS ACCESSORIES
27
3-Bay Rear Storage Give your Club Car a custom look with this 3-bay
storage unit. Formed of ABS plastic it features 3 separate, front opening
hinged lids and removable inserts. Sold unpainted it is a close match to
the standard Club Car white.
AM10608
Fits 2000-Present ICS canopy only $481.49
Club Car 1-Piece Dash Tray Additional storage room for loose items, and
add 2 cup holders with this dash tray. Made of smoked acrylic plastic with
removable drink holders, this design installs easily with basic tools. Fits
1982-present.
AM10284
With standard 2 7/8" drink holder openings $129.86
AM50396
With oversized 4" drink holder openings $132.17
Club Car Golf Car Organizer This organizer tray slips into the left and
right dashboard pockets. This design has holders for loo
| ATTICA EQUIPMENT LTD. 150 GLACIER ST. MAYFAIR INDUSTRIAL PARK, COQUITLAM, B.C. V3K 5Z6
Call Brad Porcellato, PH. 604 941-9608 FAX. 604 941-2158 CEL. 604 418-5682 HOME. 604 525-4870
OPTIONS ACCESSORIES
30
DS Cargo Box Newly designed, high quality aluminum box bed kit.
Features our new rattle free tailgate lock. Dimensions: 27.5" long, 40"
wide, 9" deep, with a payload capacity of 150 lbs. Note: Pre-2000 canopy
requires 1014503 rear brace. ICS canopy support coming soon.
AM10621
Brushed aluminum $511.26
AM10622
Black powder coated $569.03
Universal 4-passenger 80 in. canopy This 80 inch canopy is formed of
ABS plastic and is a universal fit item for Club Car, Yamaha and E-Z-GO 4
passenger golf cars. Top will require use of standard front windshield
frame and OEM 4 passenger rear support.
AM10264
White $379.35
AM10265
Beige $379.35
Touch Up Paint Designed to match all Club Car standard paint colors
since 1998. Paint comes in a 1/2 fl. oz. bottle with applicator bru
|
|
