Catalog: Fairlane Torino and Ranchero Parts & Accessories 2009 | |
| top frame rear rails must drill holes 66 71 c7oz-7653138-9b pr 259.95 ... | |
| requires 10 to 12 note for 64 fairlane holes will have to be drilled into the rocker ... | |
| base with inserts note must drill new holes to install pins are larger than ... | |
| rear where bumper mounts reinforced hole for spring shackle is 101 2 on center ... comet montego tb1018 ea 24.95 hood drilling and tapping we ll drill and tap your ... | |
| this piece mounts in the shaker drain hole located on the top surface of all ... about 4 h × 36 w × 441 2 l has two holes with screens installed cr2015 ea 149 ... points does not bolt up to factory holes cr2014 ea 149.95 fairlane torino ... be re-drilled will not fit the factory holes in the hood c9zz-16c630c ea 129.95 ... | |
| fiberglass bumpers paint to match no holes are drilled in these bumpers only ... d0oz-17626 fiberglass valances note no holes drilled indentations only d2oz-17626 ... fiberglass stone deflectors note no holes drilled indentations only note there is ... | |
| about 4 h × 36 w × 441 2 l has 2 holes with screens installed cr2015 ea 149 ... 95 fiberglass bumpers paint to match no holes for lamps or bolts each has indent for ... lower brace crossmember 62 65 hood drilling and tapping we ll drill and tap your ... | |
| air cleaner assembly stud size 1/4 20 hole not drilled and tapped all the way ... through b358871a ea 10.95 hole drilled and tapped all the way through ... | |
| use existing frames drill new hole 7071kit set 199.95 installs 429 ... | |
| b c d e f length from center or u-joint hole to end of shaft 83/32 outside-to- ... b c d e f length from center or u-joint hole to end of shaft 73/4 outside-to- ... b c d e f length from center or u-joint hole to end of shaft 83/32 outside-to- ... | |
| all with 11/16 bar will require holes to be drilled brackets are not the same ... 19.95 all with 3/4 bar will require holes to be drilled brackets are not the same ... | |
| requires 10 to 12 note for 64 fairlane holes will have to be drilled into the rocker ... | |
| the ignition coil primary winding note holes must be drilled in your hood for proper ... | |
| brake handle note for some models a new hole may have to be drilled in the shaft in ... the new handle while all of the holes were the same size the location of the ... hole varied from model to model some ... on the shaft mark the shaft where the hole in the new handle is and re-drill the ... | |
