Page 55 of BMW Catalog by BAUM Tools

deutronic dbl800 · microprocessor controlled charging testing and monitoring of batteries · switchable option to an adjustable power supply for programming/flashing of vehicle controllers · short circuit and reverse polarity protected · built-in interface for connection to computer programming units printers and large displays · fully protected against defective/shorted batteries · deep discharge refresh function for sulphated batteries special software optional · sparking is avoided by microprocessor controlled time-delay current turn-on this allows battery terminal clamps to be connected with unit on · various charging software programs included for refreshing batteries with differing fault conditions input voltage 115v/10a 103-133ac 47hz 63hz standard universal connector at front plane iec320 10a output factory settings plug-in charge cables with fully isolated clamping jaws switch-off relay output voltage monitored by over voltage protection and limited to 16vdc or alternative 32vdc if the output voltage goes to 16vdc or alternatively 32vdc for a period longer than 5 seconds the current is automatically switched off remote control switching via cable electronic current limiting adjustable charge mode factory settings the unit starts with a charging voltage of 14,2vdc if charging current falls below 2,5a then the charging voltage will drop to 13,2vdc when additional current is required the charger will again increase the charging voltage up to 14,2vdc current 45a 14.2v 55a 13.2v load regulation static 10-90 <50mvpp dynamic 20-90 <300mvpp cooling convection cooling supported by internal controlled and regulated fan controlled power reduction at high temperatures in conditions of inadequate ventilation physical specifications ambient operating temperature -20°c 40°c dimensions 240 x 295 x 120mm txbxh weight 3.9kg 8.6lb without cables without package approved by bmw ag porsche jaguar and other companies 800-848-6657 www.baumtools.com deutronic_dbl800

[close]