Catalog: Concrete Fasteners Catalog | |
| 10 p 888.498.5747 f 216.391.5352 www.confast.com TAPCON CONCRETE SCREWS ... a flat phillips #3 countersunk or a 5/16" hex washer head. All screws are ... , brick and block. Installation: (1) Drill hole into base material using the drill ... to be fastened over hole. (3) Insert point of Tapcon into hole and drive screw in ... pullout strengths. A carbidetipped drill bit is supplied with each box of TapCon ... fasteners. The correct hole must be drilled for the screw to obtain holding values ... are based on close-tolerance holes drilled with Elco carbide tipped drill bits. ... lb. 229 lb. 3/16" 1-3/4" 1090 lb. 521 lb. 1/4" 1" 800 lb. 490 lb. 1/4" ... | |
| 12 p 888.498.5747 f 216.391.5352 www.confast.com METAL HIT ANCHOR The ... the shank for a depth just beyond the point where the slot terminates in the body. ... block and brick. Installation: (1) Drill hole in base material equal to diameter ... for spacing between anchors and five (5) anchor diameters from an unsupported ... spacing should be increased. SIZE DRILL BIT MINIMUM EMBEDMENT PULL-OUT ... DATA 3/16" x 7/8" 3/16" 1/2" 500 lb. 1/4" x 1" 1/4" 1/2" 750 lb. 1/ ... | |
| 15 p 888.498.5747 f 216.391.5352 www.confast.com HANGAR MATE HangerMate ... a precision crossdrilled or straight drilled and tapped head. All anchors are yellow ... specifications, please call 1-888-498- 5747 for all current code approvals. ... ZE215 into corded screw gun (min. 4.5 amps) or appropriate cordless screw gun ... drive socket. (3) Position the self-drilling point of the anchor at the intended ... point of installation and with the screw gun ... matched tolerance carbide-tipped drill bit into hammer or rotary hammer drill ... . For SDS-drive drills use bit ZE380; for keyed chuck-type ... drills use bit ZE360. (2) With the drill in the hammer mode, drill the full ... bit. (3) Slide drive sleeve ZE220 over drill bit, locking its enternal hex recess ... | |
| 16 p 888.498.5747 f 216.391.5352 www.confast.com WALL DRILLER The Wall ... Driller is injection molded of engineered ... of the drywall. The anchor has a single point that drills a clean hole and prevents ... #2 Phillips bit tip into head of wall driller. (2) Press point into wallboard, while ... . Anchor Spacing: The forces on a Wall Driller are transferred to the material that it ... . SIZE WALL THICKNESS 3/8" 1/2" 5/8" Values shown are average ultimate ... . TECHNICAL DATA #6 Plastic 3/8" to 5/8" 25 lbs. 40 lb. 85 lb. #8 Plastic ... 3/8" to 5/8" 25 lbs. 40 lb. 85 lb. #8 Zamak ... 3/8" to 5/8" 25 lbs. 40 lb. 85 lb. PULL-OUT ... | |
