Catalog: Concrete Fasteners Catalog | |
| Anchor Lag Shield Anchor Tapcon Concrete Screws Nylon Nail-It Metal Hit Anchor ... Drive Anchor Strike Anchor Hangar Mate Wall Driller Toggler Bolt Plastic Toggler 1 ... www.confast.com YOUR ONE SOURCE FOR CONCRETE FASTENERS ... | |
| anchors are a one-piece, all steel concrete anchor. Split drive anchors are ... at the base. When driven into the concrete hole, these halves are compressed. Once ... exerts tremendous force upon the inside walls of the hole, resulting in low "slip" ... compensates for poor grade or old concrete. Split Drive Anchor can come with either ... Applications: light to medium duty in concrete. Installation: (1) Drill hole in ... concrete with carbide tipped bit meeting ANSI ... | |
| 498.5747 f 216.391.5352 www.confast.com WALL DRILLER The Wall Driller is injection ... INFO Applications: Light duty into wallboard. Do not use overhead. Installation: (1 ... Insert #2 Phillips bit tip into head of wall driller. (2) Press point into wallboard ... until it is seated flush with the wall. (3) Place fixture over hole and tighten ... . Anchor Spacing: The forces on a Wall Driller are transferred to the material ... , conduit clips, smoke detectors. SIZE WALL THICKNESS 3/8" 1/2" 5/8" Values ... lbs. 40 lb. 85 lb. PULL-OUT TEST IN WALLBOARD ... | |
| down the legs to securely "capture" the wall between the channel and the cap. The ... legs snap off easily, flush with the wall. The Toggler bolt is also available with ... duty in hollow block, hollow brick, wall board, paneling, plaster, fiberglass ... so metal channel rests flush behind wall as you slide plastic cap along straps ... hand until flange of cap is flush with wall. (3) Place thumb between plastic straps ... to side snapping off straps flush with wall. (4) Insert bolt through item to be ... with fixture. Minimum clearance behind wall is 1-7/8" Screw Length: Thickness of ... be increased. SIZE GRIP RANGE 1 5/8" WALL BOARD CONCRETE BLOCK STEEL PLATE (1) ... | |
| material (masonite, plywood, paneling, concrete, drywall, etc.) of any thickness above ... the minimum wall grip range. Anchors will perform as ... wedge or solid wall anchors in materials with thicknesses ... above wall grip range, without modification. ... Applications: Light to medium duty in concrete, brick,block, drywall, masonite, plywood ... and paneling. Installation: Hollow Wall (1) Drill 5/16" hole. (2) Fold anchor, ... anchor in hole and tap flush with wall. (3) Insert key to pop anchor open ... behind hollow wall (not necessary for thick or solid walls ... be used in solid base material such as concrete. Anchor Spacing: The forces on a ... | |
