Catalog: Concrete Fasteners Catalog
Company/Brand: Concrete Fastening Systems
drill bits in Concrete Fasteners Catalog by Concrete Fastening Systems
anchor is being driven into the hole drilled in the concrete. The other end of the ... duty into concrete. Installation: (1) Drill hole into concrete with a carbide ... tipped masonry drill bit conforming to ANSI B94, 12-77, the ... the concrete and hammer it in to the drilled hole until the threads are below the ...
, block and brick. Installation: (1) Drill hole through mounting holes in fixture ...
depth and holding power. SIZE LENGTH DRILL BIT THRD. LENGTH BOLT DIA. PULL-OUT ... duty into concrete. Installation: (1) Drill hole into concrete with a carbide ... tipped masonry drill bit conforming to ANSI B94, 12-77, ... of anchor. To set anchor below surface: Drill hole deeper than anchor length. Thread ...
, brick and block. Installation: (1) Drill hole into base material using the drill ... pullout strengths. A carbidetipped drill bit is supplied with each box of TapCon ... fasteners. The correct hole must be drilled for the screw to obtain holding values ... are based on close-tolerance holes drilled with Elco carbide tipped drill bits. ...
, block and brick. Installation: (1) Drill hole in base material using a carbide ... the spacing should be increased. SIZE DRILL BIT MINIMUM EMBEDMENT CONCRETE 3000 ...
block and brick. Installation: (1) Drill hole in base material equal to diameter ... spacing should be increased. SIZE DRILL BIT MINIMUM EMBEDMENT PULL-OUT ...
duty in concrete. Installation: (1) Drill hole in concrete with carbide tipped ... meeting ANSI standards. Hole should be drilled minimum embedment or deeper, plus 1/4 ... should be increased. SIZE MIN. EMB. DRILL BIT 3000 PSI PULL-OUT 3000 PSI SHEAR ...
heavy into concrete. Installation: (1) Drill hole of sufficient depth using a ...
a precision crossdrilled or straight drilled and tapped head. All anchors are yellow ... drive socket. (3) Position the self-drilling point of the anchor at the intended ... matched tolerance carbide-tipped drill bit into hammer or rotary hammer drill ... . For SDS-drive drills use bit ZE380; for keyed chuck-type ... drills use bit ZE360. (2) With the drill in the hammer mode, drill the full ... bit. (3) Slide drive sleeve ZE220 over drill bit, locking its enternal hex recess ... with the hex collar of the drill bit. (4) Insert appropriate HangerMate ... . disengage hammer mode and engage drill-only mode. (5) Place tip of the HangerMate ... anchor into drilled hole and drive until the safety set ...
f 216.391.5352 www.confast.com WALL DRILLER The Wall Driller is injection molded of ... . The anchor has a single point that drills a clean hole and prevents paper damage ... #2 Phillips bit tip into head of wall driller. (2) Press point into wallboard, while ... . Anchor Spacing: The forces on a Wall Driller are transferred to the material that it ...
