Catalog: Concrete Fasteners Catalog | |
| f 216.391.5352 www.confast.com LEADWOOD SCREW ANCHOR The cavity of the Leadwood screw ... from turning in the masonry. As the screw progresses deeper into the anchor, the ... anchor from twisting and allowing the screw to form its own threads. TECHNICAL ... with surface of base material. (4) Insert screw through fixture into anchor and ... tighten. Screw Length: Thickness of material to be ... for complete expansion of anchor equals screw length. Anchor Spacing: The forces on ... a Leadwood screw anchor are transferred to the material ... be increased. ANCHOR SIZE HOLE SIZE SCREW SIZE PULL-OUT 3000 PSI CONCRETE ... | |
| .5352 www.confast.com TAPCON CONCRETE SCREWS The TapCon brand concrete screw cuts ... hole in concrete, brick or block. The screw has alternating raised and lowered ... stability. The TapCon brand concrete screw is available in both 3/16" or 1/4" ... or a 5/16" hex washer head. All screws are plated using the Stalgard coating ... for ease of installation. TapCon screws are also available in 410 stainless ... a silver Stalgard. The stainless steel screws have shown no red rust in salt spray ... using the drill bit provided with the screws. The depth of the hole must be at least ... object to be fastened over hole. (3) Insert point of Tapcon into hole and drive ... screw in using a nut drive or #3 bit tip. Do ... not over torque the screw. Screw Length: The length of the TapCon ... correct hole must be drilled for the screw to obtain holding values. In all cases ... | |
| . Installation: For Metal or Wood (1) Insert HangerMate recessed drive socket ZE215 ... into corded screw gun (min. 4.5 amps) or appropriate ... cordless screw gun. (2) Insert appropriate HangerMate anchor into ... point of installation and with the screw gun operation at approximately 1800 rpm ... or component. For Masonry/Concrete (1) Insert appropriate HangerMate matched ... the hex collar of the drill bit. (4) Insert appropriate HangerMate anchor into the ... | |
| Do not use overhead. Installation: (1) Insert #2 Phillips bit tip into head of wall ... and tighten the proper size sheet metal screw. A one inch 1" minimum thread engagement ... is recommended. Screw Length: Thickness of material to be ... plus 1" penetration into anchor equals screw length. Anchor Spacing: The forces on ... | |
| off straps flush with wall. (4) Insert bolt through item to be fastened and ... clearance behind wall is 1-7/8" Screw Length: Thickness of material to be ... plus thickness of base material equals screw length. Anchor Spacing: The forces on ... | |
| form a tonjue, which allow them to be inserted in to the hole. As the screw passes ... (1) Drill 5/16" hole. (2) Fold anchor, insert anchor in hole and tap flush with wall ... . (3) Insert key to pop anchor open behind hollow ... walls). (4) Place item over anchor, insert screw and tighten until screw is flush ... . (2) Clean out hole. (3) Fold anchor, insert anchor in hole and tap flush with base ... material. (4) Place item over anchor, insert screw and tighten until screw is flush ... | |
