Catalog: Concrete Fasteners Catalog
Company/Brand: Concrete Fastening Systems
safety factor power screws in Concrete Fasteners Catalog by Concrete Fastening Systems
poor masonry or when additional holding power is needed. (2) Position the pilot end ... the forces, thus reducing the holding power of the anchor. As a rule of thumb, the ... as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally ...
the forces, thus reducing the holding power of the anchor. As a rule of thumb, the ... as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally ...
the forces, thus reducing the holding power of the anchor. As a rule of thumb, the ... as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally ...
.5352 www.confast.com TAPCON CONCRETE SCREWS The TapCon brand concrete screw cuts ... which provide exceptional holding power and stability. The TapCon brand ... or a 5/16" hex washer head. All screws are plated using the Stalgard coating ... for ease of installation. TapCon screws are also available in 410 stainless ... a silver Stalgard. The stainless steel screws have shown no red rust in salt spray ... using the drill bit provided with the screws. The depth of the hole must be at least ... tipped drill bits. Designated holding power depends on the quality of the masonry ... pullout and shear failure values. A. safety factor of 4:1. or 25% of ultimate ...
the forces, thus reducing the holding power of the anchor. When anchoring into low- ... density materials, the holding power will no be greater than that of the ... center to center to get maximum holding power in low-density materials. Depending on ... as a guide and are not guaranteed. A safety factor of 4:1 or 25% is generally ...
the forces, thus reducing the holding power of the anchor. When anchoring into low- ... density materials, the holding power will no be greater than that of the ... center to center to get maximum holding power in low-density materials. Depending on ... and are not guaranteed in any way. A safety factor of 4:1 or 25% is generally ...
and expands the legs for double holing power. The key-activated positive locking ... the forces, thus reducing the holding power of the anchor. When anchoring into low- ... density materials, the holding power will no be greater than that of the ... center to center to get maximum holding power in low-density materials. Depending on ... and are not guaranteed in any way. A safety factor of 4:1 or 25% is generally ...
