Catalog: Concrete Fasteners Catalog
Company/Brand: Concrete Fastening Systems
threaded drill bit in Concrete Fasteners Catalog by Concrete Fastening Systems
a single unit. The carbon steel rod is threaded for a portion of its length. The ... extreme end of the threaded portion is rounded to protect the ... anchor is being driven into the hole drilled in the concrete. The other end of the ... duty into concrete. Installation: (1) Drill hole into concrete with a carbide ... tipped masonry drill bit conforming to ANSI B94, 12-77, the same ... the concrete and hammer it in to the drilled hole until the threads are below the ...
to-use anchor. The anchor consists of a threaded stud with an outwardly flared cone- ... , block and brick. Installation: (1) Drill hole through mounting holes in fixture ... into the base material, using a carbide bit conforming to ANSI B94, 12-77 with the ... same size bit as anchor diameter. (2) Clean hole with ... 3) Make sure nut is flush with the top threaded part of anchor. Insert anchor assembly ...
depth and holding power. SIZE LENGTH DRILL BIT THRD. LENGTH BOLT DIA. PULL-OUT ... duty into concrete. Installation: (1) Drill hole into concrete with a carbide ... tipped masonry drill bit conforming to ANSI B94, 12-77, matching ... the bit size with the outside diameter of the ... of anchor. To set anchor below surface: Drill hole deeper than anchor length. Thread ...
, brick and block. Installation: (1) Drill hole into base material using the drill ... bit provided with the screws. The depth of ... drive screw in using a nut drive or #3 bit tip. Do not over torque the screw. ... pullout strengths. A carbidetipped drill bit is supplied with each box of TapCon ... fasteners. The correct hole must be drilled for the screw to obtain holding values ... are based on close-tolerance holes drilled with Elco carbide tipped drill bits. ...
, block and brick. Installation: (1) Drill hole in base material using a carbide ... tipped bit matching the diameter of the Nylon Nail ... the spacing should be increased. SIZE DRILL BIT MINIMUM EMBEDMENT CONCRETE 3000 ...
hole of the anchor. The anchor is threaded on the top end where the drive pin is ... heavy into concrete. Installation: (1) Drill hole of sufficient depth using a ... carbide bit the same diameter as the anchor being ... . ANCHOR SIZE THREAD LENGTH MIN. EMB. BIT SIZE SPACE BETWEEN EDGE DISTANCE ...
and reliable attachment of 1/4" or 3/8" threaded rod into concrete, steel and wood. All ... a precision crossdrilled or straight drilled and tapped head. All anchors are yellow ... drive socket. (3) Position the self-drilling point of the anchor at the intended ... is now installed and ready to accept a threaded rod or component. For Masonry/Concrete ... matched tolerance carbide-tipped drill bit into hammer or rotary hammer drill. For ... SDS-drive drills use bit ZE380; for keyed chuck-type drills use ... bit ZE360. (2) With the drill in the hammer mode, drill the full ... length of the bit. (3) Slide drive sleeve ZE220 over drill ... bit, locking its enternal hex recess with ... the hex collar of the drill bit. (4) Insert appropriate HangerMate ...
f 216.391.5352 www.confast.com WALL DRILLER The Wall Driller is injection molded of ... . The anchor has a single point that drills a clean hole and prevents paper damage ... . Installation: (1) Insert #2 Phillips bit tip into head of wall driller. (2) ... . Anchor Spacing: The forces on a Wall Driller are transferred to the material that it ...
