Page 5 of Buckeye, Cleco, Dotco Fabrication Tools by Cooper Power Tools

tool operation warning test and operate tools at 90 psig 620 kpa/6.2 bar maximum pressure measured at the tool while the tool is running unless tool is marked otherwise use recommended air line filters regulators lubricators always disconnect the air supply hose before working on the tool or changing accessories warning wear impact resistant goggles or face shield at all times the tool is in operation other protective clothing shall be worn if necessary for spark protection deflection see regulations warning immediately shut off the tool if unusual sound or vibration is detected remove and inspect the wheel and check the tool speed rpm use of over-speeding grinder or unbalanced wheels may result in serious injury warning high sound levels can cause permanent hearing loss use hearing protection as recommended by your employer or osha see 29cfr part 1910 warning each type of wheel wire brush saw blade flap wheel and other product has specific mounting procedures and regulations concerning spindles flanges blotters collets etc which shall be used wheels must mount on tool s spindle freely but not loosely spindle nuts must be tightened so as not to crack the wheel nuts must have full thread engagement warning employ a safety program to provide inspection and maintenance of all phases of tool operation and air supply equipment in accordance with safety code for portable air tools ansi b186.1 make sure that all repairs are by trained personnel only and that these safety instructions are understood by the user warning regularly inspect all wheels etc and discard cracked chipped or otherwise damaged units redress out-of-balance wheels see regulations warning when mounting any grinding wheel the tool shall be run at operating speed with the safety guard in place in a protected area such as under a work bench for at least one minute a damaged wheel should fail within that time any suspect wheel of unknown origin shall not be used and must be properly disposed warning face eye protection must be worn while operating power tools per ansi b186.1 cutting tool maximum speed rating must equal or exceed speed of air tool 90psi 620 kpa follow cutting tool manufacturer s mounting operating instructions 3

[close]