Page 76 of Engine 2008 by Custom Chrome

tappet block covers accessories tappet block covers for evolution® these die-cast tappet block covers have been re-designed to completely cover the original block mounting bolts for a custom look installation is easy with supplied silicone adhesive and does not require tappet block removal fits evolution® big twin models from 1984 thru 1999 020028 sold in pairs $55.99 u.s des pat #344,274 chrome tappet block cover sets for evolution® big twin models these unique covers are available in stamped steel and die-cast versions that fit over the original equipment tappet blocks like a second layer of skin maintaining the stock appearance each cover has a hidden slot in the back permitting it to be installed without removing your pushrods just lift the pushrod tube covers and slip them on they re held in place with silicone adhesive which is provided four 12-point chrome screws are included to replace the four zinc-plated original equipment screws which protrude slightly thru the holes in the fronts of the covers fits all evolution® big twin models from 1984 thru 1999 26172 stamped steel set shown $28.99 26171 die-cast set $30.99 chrome tappet block covers for shovelhead models fit over the original equipment tappet blocks like a second layer of skin each cover has a hidden slot in the back which permits it to be installed without removing your pushrods just lift the pushrod tube covers and slip them on they re held in place with silicone adhesive which is provided early and late-style screws are included to replace the original equipment screws fit all shovelhead models from 1966 thru 1984 26178 stamped steel set $44.99 note will not fit late 1981-early 1982 models equipped with the tappet blocks that had oil evacuation fittings engine 9 dome lifter block bolt covers don t ignore the lifter blocks when going for the full custom look set of eight covers install in seconds with included silicon adhesive 66004 fits big twins from late 1976 thru 1999 $11.99 tappet guide puller for sportster® models removes press-fit tappet guides from the crankcase after tappet body adjusting screw is removed fits sportster® models from 1957 thru 1978 20104 replaces oem 95724-57 $36.99 crankcase tappet oil screens these are the original equipment parts can be used in aftermarket applications as well fits all big twin models from 1970 thru 1999 except twin cam 88® models 75585 replaces oem 24981-70 pack of 5 $17.99 please see cautionary information following page ref.65 9.76 prices shown are suggested retail prices only actual retail prices are determined by each dealer and may vary.

[close]