occur, replace the clutch disc. WaterPump It is recommended to replace the water ... pump when installing a new engine. However, ... if the old pump is reused, check for cavitation ... and smooth bearing feel. Replace the pump if it shows signs of wear. Spark Plug ... , cracks and burrs. The distributor/oil pump drive should be free of nicks, burrs, ... conditioning compressor Power steering pump Sensors All pulleys and other bracketry ...
can be pre-lubed by priming the oil pump with a hand-held drill. Using an oil ... pump priming tool or distributor shaft, ... rotate the oil pump with a drill at 200 to 500 RPM for two ... does not seal properly to the heads, water and other contaminants can enter the ... manifold(s). 16. Install the fuel pump and fuel lines being sure of proper ... : Front end bracketry Crankshaft pulley Waterpump pulley Air conditioning compressor ... Air pump Alternator (generator) Power steering ... pump All sensors that were removed from the ...
, Front Cover, Oil Check Valve, P/S Pump Pulley, Spark Plugs, and WaterPump ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED. 12360624 138 CID Reman ... Cover, Oil Check Valve, Oil Pan, Oil Pump w/Screen, P/S Pump Pulley, Spark Plugs ... , Timing Chain Tensioner and Guides, WaterPump INSTALLATION INSTRUCTIONS This ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED ...
Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED. 12360626 138 CID Reman ... Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED ...
Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED. 12361504 138 CID Reman ... Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ... reach the full mark. CAUTION: The oil pump in this engine must be primed before ... IS STARTED WITHOUT OIL OR IF OIL PUMP IS NOT PRIMED ...
Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ... engine requires transferring the waterpump cover from the original engine. ... This is necessary to ensure that the waterpump cover contains the nipple required ... for the heater hose. The waterpump cover gaskets should be replaced at ... Cover, Oil Check Valve, Oil Pan, P/S Pump Pulley, Spark Plugs, and WaterPump ...