Catalog: Bore Line Hole Making
Company/Brand: Ingersoll Cutting Tools
cutting parameters in Bore Line Hole Making by Ingersoll Cutting Tools
stability and clamping machining parameters workpiece configuration material ...
manufactured regrinding may change the cutting geometry but the pad form will remain ... the same all cross section profile parameters such as p la and must be precisely ...
point replacement indications 1 limit cutting edge wear to .008 to .012 see fig 1 2 ... hole depth is less than 1xd and reduced cutting parameters are applied coolant mix ...
turret is required · the recommended cutting parameters for 8:1 drills is 20 lower ... than the cutting speeds used for the 3:1 and 5:1 drills ...
indexable drills are one-effective cutting geometry regardless of the number of ... and possible drill failure operating parameters should be adjusted to fall within ...
guidelines recommendations are starting parameters only and can be effected by cutting ... drill performance if not possible then cutting parameters may have to be reduced start ... midpoint of the range and adjust the cutting parameters according to your cutting ... remainder of the cut cont iso material cutting number speed sfm 1 2 3 4 5 6 7 8 9 10 ...
have some effect on tool life operating parameters may have to be adjusted accordingly ...
