3 search results for cutting speed for threading in 0.258 seconds found

Turning Grooving 2016

trace remains at the groove bottom countermeasures 1 increase the cutting speed for finishing process only this can handle most of the cases if the ... unbalanced load applied on only one side of the cutting edge before turning pull the tool back about 0.1mm after ... guide for grooving [gvf insert a inserts b ... 0.5mm at roughing refer to fig.4 before turning pull the tool back about 0

Turning Grooving 2016

.031 • above cutting condition is for external grooving set both cutting speed and feed 20 higher for internal grooving wet � 1st ... .031 • above cutting condition is for external grooving set both cutting speed and feed 10 higher for internal grooving mega indicates megacoat 800 ... 188n • above cutting condition is for external grooving set both cutting speed and feed 10 higher for internal grooving mc indicates megacoat

Turning Grooving 2016

max 0.047 above cutting condition is for external grooving set both cutting speed and feed 10 lower for internal grooving 800.823.7284 notes ceramic ... 0028~0.0079 above cutting condition is for external grooving set both cutting speed and feed 10 lower for internal grooving b index 490~720 490~720 330~ ... recommended cutting conditions � gh ground ... max 0.031 � max 0.047 above cutting condition is for external grooving