Page 7 of AM/FM Tuner Module by McIntosh Laboratory, Inc.

mht series component installation instructions audio pc board to the four pin pc board socket j5 of the module j4 which is the middle j5 one of the three inline connectors j3 14 also attach the remaining plug of the seven conductor cables from am/fm ribbon cable main audio tuner coming from the pc board module seven pin socket figure 15 j1 as indicated on the mht series main component audio pc board to the seven pin pc board socket j4 of the module which is located closest to the mht series component front panel reinstalling cover and setup in the following steps the mht series component setup feature will be accessed to select the country of operation for proper am and fm reception the setup mode is onscreen video based menu and can be viewed by connecting the mht series component monitor a video output s-video or composite to a tv/monitor this will allow for verifying the tuner country setting 15 reinstall the mht series component top cover refer to steps 2 and 3 on page 5 16 secure the mht series component top cover to the rear panel with the two screws that were previously removed 17 reinstall the four screws to the sides of the mht series component a/v system controller 18 reconnect the hookup connecting cables to the rear panel of the mht series 19 place the mht series main power switch to the on position and press the standby/on push-button refer to figure 16 note refer to the mht series component owner s manual for additional operational details 20 press and hold the front panel setup push-button approximately three seconds to enter the setup mode the word setup will appear on the mht series component front panel display and the main system setup menu will appear on the monitor/tv screen 21 using the up or down directional push-buttons select system settings on the on-screen menu followed by the select push-button on the remote control the on-screen menu item tuner indicates the current country setting of the tm1 am/fm tuner module if it needs to be changed to a different country group perform step 22 if not go to step 23 refer to figure 17 menu system setup 1 video 2 tuner 3 temp display 4 osd routing 5 video format ntsc usa full both auto exit figure 17 note the some mht series components have additional menu items e.g osd routing and video format that will not appear on other mht series component on-screen menu 22 with the mht series component in the standby mode press the standby/on push-button followed by immediately pressing and holding in the appropriate front panel push-button push-button country group trim down usa trim up europe late night japan note the front panel alphanumeric display will indicate the specific mht series component model number followed by tuner usa or tuner europe or tuner japan the mht series component default operational setting for the tm1 am/fm tuner module is usa to check the current setting perform the following 23 verify the am and fm tuner is functioning properly figure 16 7

[close]