Page 9 of AM/FM Tuner Module by McIntosh Laboratory, Inc.

c45 installation instructions four pin socket of the module which is the middle one of the three in-line connectors 14 also attach the remaining plug of the seven conductor ribbon cable coming from the seven pin socket j21 as indicated on the c45 data pc board to the seven pin socket of the module which is located closest to the c45 front panel din connector note refer to the c45 owner s manual for additional operational details tm1 label f connector reinstalling cover and setup in the following steps the c45 setup feature will be accessed to select the country of operation for proper am figure 22 and fm reception the setup mode is indicated on the cables front panel alphaj3 from numeric display main j5 refer to figures 24 pc 25 and 26 board j4 15 reinstall the c45 top cover refer to steps main pc 2 and 3 on j23 board page 3 16 reconnect the j22 hookup conj21 necting cables to the rear panel of the c45 am/fm tuner 17 place the c45 module main power switch to the figure 23 on position and press the standby/on push-button 18 press the setup push-button to enter the setup mode 19 press the menu tone bypass push-button and the last selected setup mode will appear on the front panel alphanumeric display if necessary continue to press the menu push-button until version appears on the display the character on the far right side of the firmware version number display indicates which country the tuner is setup for proper operation refer to figure 24 alphanumeric display country group version u usa version j japan version e europe note if the character on the far right side of the display is an u the tuner is set for reception in the usa if the tuner is setup for the country it will be operated in proceed to step 23 if not then perform the following steps first 20 press the menu push-button until the front panel alphanumeric display indicates country code refer to figure 25 figure 25 21 press the trim level up or down push-button to change the country group refer to figure 26 figure 26 22 press the setup push-button to exit the setup mode 23 verify the am and fm tuner is functioning properly figure 24 9

[close]