Catalog: AM/FM Tuner Module | |
| mx119 mx134 or mx135 removing covers 1 remove all connecting cables from the ... rear panel of the mx119 mx134 or mx135 cover screws a/v controller 2 remove two ... screws from each side and two screws from the back that ... secure the top cover to the mx119 mx134 or mx135 3 lift off ... the top cover by grasping the rear sides of the top cover and lifting up and ... or mx135 4 remove the inside connector cover which is secured with two phillips head ... screws and is lofigure 3 cated on the rear panel refer to figures 3 and 4 note ... direction do not force it on backward rear panel inside cover data pc board ... atrear panel tached to the outside rear panel inside cover of the bag refer to ... from the bag and attached it to the rear panel of the mx119 mx134 or mx135 below ... | |
| mht series component removing covers 1 remove all connecting cables from the ... rear panel of the mht series a/v system ... 2 remove two screws from each cover side and two screws from the back screws ... that secure the top cover to the mht series component 3 lift off ... the top cover by grasping the rear sides of the top cover and lifting up and ... 4 remove the inside connector figure 10 cover which is secured with two phillips head ... screws and is located on the rear panel refer to figures 10 and 11 note ... direction do not force it on backward rear panel inside cover figure 11 6 in a ... the prej1 cables viously installed rear panel cables so openings that they will ... from the bag and attached it to the rear panel of the mht series component below ... | |
| component front panel reinstalling cover and setup in the following steps the ... reinstall the mht series component top cover refer to steps 2 and 3 on page 5 16 ... secure the mht series component top cover to the rear panel with the two screws ... 17 reinstall the four screws to the sides of the mht series component a/v system ... the hookup connecting cables to the rear panel of the mht series 19 place the ... | |
| c45 removing covers 1 remove all connecting cables from the ... rear panel of the c45 audio control center 2 ... remove two screws from each side and two screws from the back that ... secure the top cover to the c45 3 lift off the top cover by ... grasping the rear sides of the top cover and lifting up and away from the c45 4 ... remove the inside connector cover which is secured with two phillips head ... screws and is located on the rear panel refer to figures 18 19 and 20 ... later to install the am/fm tuner module cover screws figure 18 installing the cables ... the c45 main pc board refer to figure 1 rear panel inside on page 3 figures 20 and ... through the lower opening of the c45 rear panel the cover was previously removed ... secure the module figure 20 to the c45 rear panel with the two phillips head screws ... | |
| tm1 label f connector reinstalling cover and setup in the following steps the ... 26 board j4 15 reinstall the c45 top cover refer to steps main pc 2 and 3 on j23 ... j22 hookup conj21 necting cables to the rear panel of the c45 am/fm tuner 17 place ... display the character on the far right side of the firmware version number display ... note if the character on the far right side of the display is an u the tuner is ... | |
| mr85 removing covers 1 remove all connecting cables from the ... rear panel of the mr85 am/fm tuner cover screws 2 remove two screws from each ... side and two screws from the back that ... secure the top cover to the mr85 3 lift off the top cover by ... grasping the rear sides of the top cover and lifting up and away from the mr85 4 ... remove the inside connector cover which is secured with two phillips head ... screws and is located on the rear panel refer to figures 27 and figure 27 ... shipping carton and attach the plug of rear the six conductor ribbon cable to panel ... figure 28 of the four conductor ribbon rear panel openings cable to the four pin ... from the bag and attached it to the rear panel of the mr85 below the opening ... through the lower opening of the mr85 rear panel the cover was previously removed ... | |
| to the mr85 front panel reinstalling cover and operation check in the following ... 34 35 and 36 15 reinstall the mr85 top cover refer to steps 2 and 3 on page 10 16 ... the hookup connecting cables to the rear panel of the mr85 17 place the mr85 ... v the character on the far right side of the firmware version number display ... note if the character on the far right side of the display is an u the tuner is ... | |
