Page 9 of Aeroquip Adapters and Tube Fittings by Moreland Hose and Belting

versil·flaretm tube fittings adapters and tube fittings one inventory of bodies any standard sae 37° flare fitting allows both flareless and flared type connection of standard steel hydraulic tubing it is no longer necessary to inventory flared tube fittings plus the special bodies nuts and sleeves for flareless tube fittings the aeroquip total tube fitting concept reduces inventory expense aeroquip flareless tube fitting aeroquip flared tube fitting the aeroquip flareless tube fitting can use any standard sae 37° male flare adapter or hose fitting as a body this eliminates the need to inventory special flareless tube fitting bodies and results in reduced inventory expense aeroquip flareless tube fittings are available in size from 3/16 tube o.d to 2 tube o.d presetting tools and extra assembly time are eliminated because there s no need for flaring special preparation or presetting with the aeroquip flareless tube fitting the chance of assembly error is reduced because the ferrule can be installed only one way and assembly is the same for all sizes and tube wall thicknesses this assures a tight joint every time these features improve production rates the aeroquip industrial standard three piece flare type tube fitting can be used on the full range of standard steel hydraulic tubing in various wall thicknesses from 3/16 tube o.d to 2 tube o.d all three components are constructed from high quality zinc plated steel for long service life the standard sae 37° flare angle is used to produce a highly efficient seal under hydraulic pressures the sleeve is used to help support the tube and absorb vibration assembly is easy a properly sized wrench and flaring tool are all that is necessary this is important in tight locations aeroquip standard sae 37° flare type fittings can also be disassembled and re-assembled repeatedly aeroquip quality is built into every component to assure leakproof connections the aeroquip standard sae 37° flare type tube fitting conforms to the following hydraulic tube fitting standards military specification mil-f-18866 and society of automotive engineers sae j514 tubing selection and sizing aeroquip flareless and standard sae 37° flare type tube fittings can be used with sae j-525 electric resistance welded cold worked annealed sae j-524 seamless annealed tubing and sae j527 brazed double wall low carbon steel tubing sae j356 welded flash controlled normalized steel tubing can only be used with aeroquip flareless tube fittings the maximum hardness of the above tubing should not exceed rockwell b65 selection of proper tubing material size and wall thickness depends on corrosion conditions pressure and flow requirements and other operating requirements of the system this page is part of a complete catalog which contains technical and safety data that must be reviewed when selecting a product 189

[close]