3 results for copper tube flaring standard found in 0.000 seconds

hose assemblies replace troublesome copper tubing running from the air compressor ... heat and they are easy to install with standard air brake nuts and sleeves no special ... f to +450°f length 1/2 hose i.d ­ 1/2 tube size 24 30 36 48 24 30 36 48 24 ... 30 36 48 length 1/2 hose i.d ­ 1/2 tube size 5/8 hose i.d ­ 5/8 tube size 5/8 ... hose i.d ­ 3/4 tube size 24 36 24 36 24 36 length 1/2 ... hose i.d ­ 5/8 tube size 34 40 38 42 48 50 52 54 67 ... to male air brake 5/8 hose i.d ­ 5/8 tube size 5/8 hose i.d ­ 3/4 tube size ... to sae 45° flare 5/8 hose i.d ­ 3/4 tube size air compressor discharge teflonŽ ...

pressure up to 10,000 psi depending on tube size and fitting construction ... zinc yellow dichromate finish used with copper brass steel aluminum and other tubing ... asa asme sae and ms specifications and standards ordering information to order a 3-piece ... 1-1/2 2 2000 1500 1500 1125 1000 1000 tube o.d thread 1/8 3/16 1/4 5/16 3/8 1/2 5/ ... 24 3/8-24 7/16-20 1/2-20 9/16-18 3/4-16 tube o.d thread 3/4 7/8 1 1-1/4 1-1/2 1 7/8- ... 3-piece ref sae no 070115 ref ms51533 tube o.d 1/8 3/16 1/4 5/16 3/8 1/2 5/8 3/4 7 ... /8 1 1-1/4 1-1/2 2 tube o.d tube o.d inch metric size size 1/4 5/16 3/8 ... ref sae no 070110 ref ms51531 tube o.d 1/8 3/16 1/4 5/16 3/8 1/2 5/8 3/4 7 ... /8 1 1-1/4 1-1/2 2 tube o.d 1/4 5/16 3/8 1/2 5/8 3/4 tube o.d 1 ... 2-piece nut ref sae no 070111 adapts standard sae flare-twinŽ fittings for use with ...

pressure up to 10,000 psi depending on tube size sealing method 3-piece bite-type ... used with aluminum hard or half-hard copper steel stainless steel monel titanium ... that cannot be flared advantages no tube flaring used with extra heavy wall ... asa asme sae and ms specifications and standards ordering information fittings are ... 267 1 slide nut and then sleeve on tube shoulder of sleeve `a must be toward ... nut 2 insert tube into presetting tool be sure that tube ... is bottomed on fitting tube stop at point `b lubricate threads ... nut slowly with wrench while turning tube with other hand when the sleeve grips ... the tube that is when the tube can no longer be turned by hand ­ stop ... proper installation of ermetoŽ fittings tube o.d thread tube o.d thread 1/8 3/16 1/4 ...