Page 28 of High Frequency Coaxial Connectors by Murata Manufacturing Co.,Ltd.

!note · this pdf catalog is downloadedand !caution formurata manufacturing co ltd therefore it s specifications are subject to change or our products in it may be discontinued without advance notice please check with our !note · please read rating from the website of storage operating rating soldering mounting and handling in this catalog to prevent smoking and/or burning etc sales representatives or product engineers before ordering · this catalog has only typical specifications because there is no space for detailed specifications therefore please approve our product specifications or transact the approval sheet for product specifications before ordering · this pdf catalog has only typical specifications because there is no space for detailed specifications therefore please approve our product specifications or transact the approval sheet for product specifications before ordering o30e.pdf 05.8.8 notice s notice soldering and mounting 1 reflow soldering soldering must be carried out without exceeding the allowable soldering temperature and time shown within the shaded area of figure allowable temperature and time of reflow soldering in case the soldering is repeated the maximum time in figure allowable temperature and time of reflow soldering should be accumulated time the standard soldering conditions are shown in figure reflow soldering standard conditions follow standard pattern dimensions 2 soldering by soldering iron soldering by soldering iron should be carried out in accordance to the following conditions pre-heating temperature 150d time 60 to 120 s soldering temperature at the tip of the soldering iron less than 350d time less than 3 s 3 we cannot warrant against mishaps caused by any use of this product that deviates from allowable temperature and time of reflow soldering 4 in soldering do not apply excessive mechanical force to terminals or leads greater than specified in the drawing 5 please note the following in case of soldering terminals or leads of the product 1 use rosin based flux but not with strong acid flux chlorine content should be less than 0.20wt 2 flux should be thoroughly cleaned from connector to prevent possible deterioration of electrical characteristics 6 please mount this product at the position so that stress by wrap and/or bend of the pcb may not apply to it 7 please dry out this product immediately after soldering and cleaning continued on the following page allowable temperature and time of reflow soldering 260 250 temperature d 240 230 220 210 200 190 180 30 60 90 120 time sec 150 180 210 240 solder sn-3.0ag-0.5cu reflow soldering standard conditions peak temperature 250±5d temperature d 240 230 150 100 25 0 pre-heating 150±20d 4 time sec 30 sec max 60-120 sec 30-50 sec measuring point of temperature in-out terminals of the device reflow soldering both convection and infrared rays hot air hot plate 27

[close]