Page 59 of Constant Velocity Joints for Industrial Machines by NTN Corporation Japan

usage and handling 3 coupling step 1 place the boot bands both large diameter and small diameter over the shaft and shift them to the steel pipe side then fit the boot over the shaft photo 21 photo 21 step 2 fit the square-section circlip into the groove on the shaft 1 photo 22 1 for installation procedure with the square-section circlip see sec 4.5 on page 59 squaresection circlip photo 22 step 3 inject ntn provided authorized grease into the cvj assembly photo 23 photo 23 step 4 fill ntn provided authorized grease into the boot about 1/3 to 1/2 as much as the space photo 24 apply ntn grease for constant velocity joints to the splines on the shaft photo 24 57

[close]