Catalog: Tube Fabricating Equipment
Company/Brand: Parker Hannifin Corporation Instrumentation Products Division
|
| | Hand Pump Enerpac Pump P-392 5/8" 10 10 Body Die Size 10 Nut Die Hose ... that the tapered end of the Ferrule(s) point toward the body die. 2. Insert U-shaped ... ram reaches a positive stop. At this point an increase in resistance of the handle ... shoulder of the body die (Figure 4). 5. Release the hydraulic pressure by ... finger tight. 8. Tighten the nut with a wrench the additional amount shown in Table1 ... increase in torque is not felt early in wrench makeup, the pre-set assembly was not ... If this happens, tighten the nut with a wrench until the torque increase is felt. Then ...
|
| | that the tapered end of the Ferrule points toward the body die. 2. Insert U-shaped ... ram reaches a positive stop. At this point an increase in resistance of the handle ... shoulder of the body die (Figure 4). 5. Release the hydraulic pressure by ... finger tight. 8. Tighten the nut with a wrench the additional amount shown in Table 2 ... increase in torque is not felt early in wrench makeup, the pre-set assembly was not ... If this happens, tighten the nut with a wrench until the torque increase is felt. Then ... Nut Die 1/4 2" 3/8" 2-1/8" 1/2" 2-3/8" 5/8" 2-3/8" 3/4" 2-3/8" 7/8" 2-5/8" 1 ... " 2-5/8" 1-1/4" 3" 1-1/2" 3-3/8 Tube O.D. L ... Size 20 24 32 Turns 5/8 5/8 3/4 ...
|
| | Huntsville, Alabama 9 Parker Rotary Wrench Assembly Kit PAK-32 HYTORC L TUBE O. ... D. The Parker P32 Rotary Wrench Size 1-1/4 thru 2 The patent pending ... rotary wrench assembles and disassembles large size ... safely and effortlessly. The Rotary Wrench reduces long-term maintenance costs. To ... steps: 1. Pin reaction pad F to rotary wrench. 2. Open outer and inner rotary wrench ... nut hex. Place split insert in rotary wrench head. Make certain drive teeth mesh. 4 ... then outer cap screws to secure rotary wrench head and hex insert. 5. Position rotary ... wrenchs hex insert on tube fitting nut. 6. ... need for hydraulic pre-setting and hand wrench tightening. No bulky wrenches to create ... ratcheting action of the PAK-32 Rotary Wrench to find wrench tight prior to assembly ...
|
| | Huntsville, Alabama 17 A A B 8 7 6 5 4 3 2 1 A B Gaugeability Assembly ... body.) Tighten nut finger-tight. 5. From finger-tight position, wrench 1-1 ... 1/8" and 3/16" size tube fittings only wrench 3/4 turn from finger tight position). ... Hold fitting body hex with second wrench to prevent body from turning as you ... body hex. If gauge DOES NOT FIT AT ANY POINT between them, you have correctly ... the nut by hand. Rotate the nut with a wrench to the original position as indicated ... nut finger tight. Then tighten nut with wrench an additional 1-1/4 turns indicated ... below. Hold fitting body with a second wrench to prevent body from turning. It is ... the nut by hand. Rotate the nut with a wrench to the original position as indicated ...
|
