Page 13 of Patriot Gear and Turnout Lockers 2009 by Penco Products, Inc.

specifications all-welded build heavy duty lockers all locker body components made of cold rolled steel specially formed for added strength and rigidity and to ensure tight joints at fastening points locker body sides bottoms tops and shelves 16 gauge steel sides punched for shelf locations on nominal 12 inch centers backs solid 18 gauge steel groups to 48 inches 1.219 m wide one piece back groups over 48 inches 1.219 m wide two piece back frame 16 gauge formed in a channel shape with hemmed edge sides 16 gauge sheet steel with 3/4 inch 19mm wide by 1-1/2 inch 38mm high diamond-shaped perforations optional solid sides without ventilation tops notched and formed sheet one continuous flat top for each group of lockers channel base notched and formed sheet one continuous bottom for each group of lockers suitable for anchoring to wood or concrete bases adds 4 inches to the overall height of locker shelves flanged four sides with additional return flange on front edge to increase strength color as selected from manufacturer s standard colors gear lockers ­ same as above with the following substitutions and additions doors one piece 14 gauge sheet steel standard ventilation 6 inch 152.4 mm wide by 3/4 inch 19 mm high horizontal louvers arranged in two groups of six optional ventilation 3/4 inch 19 mm wide by 1-1/2 inch 38 mm high diamond-shaped perforations or 3/4 inch 19 mm wide by 1/4 inch 6.4 mm high security mini louvers solid doors door frames 16 gauge formed in a channel shape with continuous vertical door strikes hinges continuous type 16 gauge piano hinge measuring full height of door welded to door and attached to locker frame using steel rivets door handles and latching cremone latching handle shall be a heavy duty turn handle that secures the door at three points the top and bottom frames are engaged with 3/8 inch 9.5 mm steel rods and a 1/8 inch 3 mm thick center latch engages at the side double door configurations shall consist of a left hinged door secured its full length by the right hinged door when latched handle assembly shall be secured to door using a threaded lock nut to facilitate adjustment and removal for repair if necessary welded handle assemblies shall not be accepted single point latch 24 wide single door only recessed handle with integral pull and 11 gauge steel hasp welded to locker frame multiple point latch 24 wide single door only recess finger-lift control handle in door positive automatic type latching whereby locker may be locked when open then closed without unlocking interior equipment shelf 16 gauge full width located approximately 12 inches 304.8 mm below top of locker hooks and coat rod two heavy duty 3 high 7/8 wide 2-1/2 inch deep single-prong wall hooks and one heavy duty chrome plated 1 inch diameter coat rod fabrication fabricate lockers square rigid without warp with metal faces flat and free of distortion finish finish coat shall be electrostatically applied powder coat enamel properly cured to paint manufacturer specifications to achieve optimum performance all lockers shall be painted inside and outside with the same color powder coat dry thickness of 1 to 1.2 mils 0.025 to 0.03 mm 13 www.pencoproducts.com 800.562.1000

[close]