PowerPatch™ Three Component Patch for Concrete 09/10 by Powers Fasteners

More catalogs by Powers Fasteners | PowerPatch™ Three Component Patch for Concrete 09/10 | 4 pages | 2015-02-04

Ads

Contacts for Powers Fasteners

Powers Fasteners
2 Powers Lane
Brewster, NY 10509

P: 800-524-3244
F: 877-871-1965
Email: info@powers.com or engineering@powers.com
http://www.powers.com/

PowerPatch™ Three Component Patch for Concrete 09/10 is listed under these categories

Industrial Supply > Fasteners & Hardware

Featured catalog pages of PowerPatch™ Three Component Patch for Concrete 09/10

new powerpatch concrete patching kit product description powerpatch is a rapid setting 100 solids high strength all-weather spall repair and patching material for concrete powerpatch uses a unique hybridized epoxy urethane system and an engineered aggregate for superior performance in all conditions general applications and uses • spall repairs and patching on bridge decks • traffic area spall crack repairs and patching • freezer floor repairs • airport runways taxiways and aprons • patching prior to coating application features and benefits • meets fda requirements • open to traffic in 15 to 30 minutes see cure schedule • fast initial set rapid gain to ultimate strengths • easy 1:1 mix ratio limitations mix only quantities that can be used within the pot life of the material shelf life 1 year in original unopened container storage conditions do not store above 85˚f or in direct sunlight kit contents should be preconditioned to

powerpatch mixing procedures have all components and tools ready and patch area properly prepared prior to mixing/placement mixing container tools and patch area should be clean and dry prior to use 1 shake component b for 30 seconds 2 vigorously mix components a and b for 30 seconds at 200-300 rpm with a jiffy mixer on a 1/2 drill 3 begin adding component c and mix for another 30 seconds until all of the aggregate is wetted out 4 place product immediately mixing smaller quantities 1 shake component b for 30 seconds 2 mix equal parts 1:1 ratio of components a and b vigorously for 30 seconds 3 add 3 parts by volume of component c to 1 part mixed a b components and stir for 30 seconds until aggregate is wetted out 4 place product immediately finishing powerpatch should be tamped into the entire patch area with the blunt end of a 2x4 or similar object to properly wet the substrate it should then be troweled and finished immediately finished patch should be level and not higher than the

powers fasteners branch information powers branch information usa locations city address contact alabama atlanta boston charlotte chicago dallas denver detroit florida houston indianapolis kansas city st louis los angeles maryland milwaukee minneapolis nashville/memphis new orleans new york philadelphia phoenix pittsburgh portland rochester salt lake city san francisco seattle 5405 buford hwy suite 410 norcross ga 30071-3984 5405 buford hwy suite 410 norcross ga 30071-3984 2 powers lane brewster ny 10509 349 l west tremont avenue charlotte nc 28203 2472 wisconsin avenue downers grove il 60515 10625 king williams drive dallas tx 75220 2475 west second street #35 denver co 80223 21600 wyoming avenue oak park mi 48237 9208 palm river road bldg 3 suite 305 tampa fl 33619 13833 north promenade suite 100 stafford tx 77477 15290 stony creek way noblesville in 46060 716 east 16th avenue north kansas city mo 64116 2761 dow avenue tustin ca 92780 3137-b pennsy drive landover md 20785 12020 w