3 results for stud 58 in found in 0.000 seconds

[hrc 26 32 36 40 44 47 50 53 56 58 material strength [psi 128,000 146,000 ... and shear stresses 2.3.1 cam follower stud bending stress if the load over the ... fig.2 assuming that the cam follower stud has been tightly mounted in a housing ... and strain as m b f b 1 2 32 [in lbf 2 where b outer ring width [in 1/ ... 32 cam follower overhang [in 1/32 b c max 3,237 f i eff d [psi 1 ... lbf leff length of outer ring contact [in d outer ring diameter [in f housing ... moment arm it can be shown that for infinite life the ultimate tensile strength of ... 1 theoretical moment arm without stud deflection sizes 160 and above 1/16 ... moment generates a bending stress in the cam follower stud of approximate ... max 3,237 3,000 lbf 149,800 psi 0.8 in 1.75 in where sd=stud diameter [in ...

the hardness in other areas of the stud is typically in a range of hrc 20 -22 ... rbc bases the maximum allowable load of stud type cam followers on a theoretical ... stud bending stress of 100,000 psi standard ... stud cam followers and heavy stud cam followers differ in stud diameter ... to impact loading for the heavy stud version high stud strength cam ... are available by special order in most applications the stud will deflect ... may not be sufficient to avoid damage in severely misaligned applications where ... yoke rollers are mounted with a pin in a yoke under load the pin is subject to ... so that bending stress can be ignored in case of widely spaced pin supports the ... determine the shear stress of the .375 in diameter pin for yoke roller y 40 l ...

rollers rbc yoke rollers correspond in many respects to the same size cam ... they are mounted on a pin for use in yoke type applications for greater ... the pin and use a press fit for the inner ring a soft pin and light press or push ... the pin should have a suitable lead-in chamfer or radius to prevent scoring ... service life etc for relubrication in service mineral oil or any good roller ... grease on mineral oil basis may be used inquire about compatibility of greases with ... be relubricated from both ends of the stud and through the housing table 2 lists ... on a hardened and ground shaft hrc 58 min 16 rms min surface finish or can be ... used with matching inner rings operating without an inner ring ...