Page 151 of Wood Construction Connectors 2006 Catalog by Simpson Strong-Tie

Model No. Ga Fasteners Doug-Fir Larch/So. Pine Allowable Loads 1,2 Spruce-Pine-Fir Allowable Loads 1,2 To Rafters/ Truss To CMU Uplift 4 Lateral (133/160) Uplift 4 Lateral (133/160) (133) (160) F1 F2 (133) (160) F1 F2 2-10dx1 1265 1265 HM9KT 18 4-SDS x1 5- 5- x1 Titen 4- x1 Titen 6- x1 Titen 6- x1 Titen 6- x1 Titen 6- x1 Titen x2 Titen 595 595 425 200 595 595 425 200 HGAM10KTA 14 4-SDS x1 850 850 1005 1105 850 850 870 815 H16 18 18 2-10dx1 1470 1470 1470 1470 1265 1265 1470 1470 1265 1265 1470 1470 1265 1265 H16S 3,4 6x2 Titen 6x2 Titen W L 1 11 4x2 Titen 6 18 1 1 2-10dx1 18 H16-2 6x2 Titen 3 2-10dx1 18 H16-2S 6x2 Titen To Concrete 3 18 3 11 Code Ref 125 Presloped at 5:12. Pitch of 3:12 to 7:12 is acceptable H16 (H16-2 similar) 3 HM9 Attaching Truss to Masonry 1 H16S Installed into Masonry HGAM10 1.Loads have been increased 33% and 60% for earthquake or wind loading with no further increase allowed; reduce where other loads govern. 2.Allowable loads are for one anchor. A minimum rafter thickness of 2 must be used when framing anchors are installed on each side of the joist and on the same side of the plate. 3.The HM9KT and HGAM10KTA come with SDS and Titen screws. 4.Minimum edge distance 1 using Titen screws. 5. See page 147 for Titen screw information. 6. Table allowable loads were determined using test ultimate/3 or nail calculation values. 7. NAILS: 10dx1 0.148" dia. x 1 long. See page 16-17 for other nail sizes and information. 2 HGAM10 Installed into Masonry The HM9 is designed to retrofit roof truss/rafters for block construction. The HM9 hurricane tie provides high uplift and lateral capacity using Simpson concrete fasteners. The presloped 5:12 seat of the H16 provides for a tight fit and reduced deflection. The strap length provides for various truss heightup to a maximum of 13 ". Minimum heel height for H16 series is 4". MATERIAL: See table. FINISH: Galvanized; see Corrosion-Resistance, page 6-7. INSTALLATION: Use all specified fasteners. See General Notes. HGAM10 can be installed into grouted concrete block. Screws are provided. Hurricane Ties do not replace solid blocking. Attach to grouted concrete block with a minimum one #5 rebar horizontal in the top lintel block. CODES: See page 12 for Code Listing Key Chart. HM9 Moisture barrier not shown (Typ.) 152 Masonry Connectors H Seismic Hurricane Ties

[close]