Page 178 of Wood Construction Connectors 2006 Catalog by Simpson Strong-Tie

Model No. W Fasteners Allowable F1 Loads (100) FC4 3 8-16d 800 FC6 5 10-16d 920 Code Ref. 3, 39, 88, 121 1. Loads may not be increased for short-term loading. 2. A 2 minimum lumber thickness is required to achieve the full load. 3. NAILS: 16d 0.162" dia. x 3 long. See page 16-17 for other nail sizes and information. FC Typical FC Load Installation For fast, accurate framing. Three-dimensional nailing pattern results in high-strength joint values. Ideal for fence construction. MATERIAL: 16 gauge. FINISH: Galvanized INSTALLATION: Use all specified fasteners. See General Notes. CODES: See page 12 for Code Listing Key Chart. An interlock provides alignment control and correct nailing locations. For a rafter-to-face connector, flatten the top flange into the face plane. The RR may be used with any rafter sloped up to 30 . MATERIAL: 18 gauge FINISH: Galvanized INSTALLATION: Use all specified fasteners. See General Notes. CODES: See page 12 for Code Listing Key Chart. Model No. Min. Rafter Size Fasteners Uplift (133/ 160) Allowable Loads 1 Header Rafter DF/SP Floor (100) Roof (125) RR 2x6 4-10dx1 4-10dx1 365 130 415 Code Ref. 4, 37, 87, 121 1. Floor loads may be adjusted for other load durations according to the code, provided they do not exceed the table roof loads. 2. NAILS: 10dx1 0.148" dia. x 1 long. See page 16-17 for other nail sizes and information. RR Typical RR Installation SH2-R Typical SH2-R Installation MATERIAL: 18 gauge FINISH: Galvanized INSTALLATION: Install in pairs. SH2-R contains four parts. No angle cuts required. Allows for square cut lumber Remove cross brace for easy storage. Install with SD8x1.25 screws (not included). 179 Miscellaneous SH2 Sawhorse Brackets FC Framing Clips RR Ridge Rafter Connector PSCL Panel Sheathing Clips 1. Reference 1997 UBC Table 23-II-E-1 and 2000 IBC Table 2304.7 (3) for span rating. Steel panel sheathing clips include model sizes PSCL , PSCL , PSCL , PSCL , PSCL PSCL , PSCL . MATERIAL: 20 gauge FINISH: Galvanized INSTALLATION: Use the same size sheathing clip as the panel thickness. Spans may be reduced for low slopes (per the APA Residential Design/Construction Guide). CODES: See page 12 for Code Listing Key Chart. Span Rating Panel Thickness Maximum Roof Sheathing Span PSCLs Per Span With PSCL Without PSCL 24/0 24 20 1 24/16 24 24 1 32/16 32 28 1 40/20 40 32 1 48/24 48 36 2 Code Ref. 180 , , PSCL Typical PSCL Installation

[close]