Page 187 of Wood Construction Connectors 2006 Catalog by Simpson Strong-Tie

188 Hanger Options HANGER OPTIONS MATRIX BASE MODEL SERIES B 45 45 EG 45 45 GB 45 GH 45 GLS 50 45 GLT/GLTV 50 45 HB 45 45 HGB 45 HGLS 50 45 HGLT/HGLTV 50 45 HGUS 45 HHB 45 HHUS 45 45 HSUR/L 1,8 8 45 HU 7 HTU 67 45 LTHJR/L 67 45 6 HUS HUSTF HUTF 5,7 45 45 HW/HWI 3 84 45 HWU 4 45 45 LBV 2 45 45 LEG 45 45 LSU/LSSU 45 45 MBHA 45 MEG 45 45 MSC 45 45 SUR/L 1,8 8 45 THASR/L 84 U 7 THGB/THGBH 67 45 W/WI 3 84 45 WM/WMI 45 45 45 45 WNP/WP/WPI 3 84 45 WPU/WNPU 4 45 45 Skewable Slopeable Slopeable Skewable Sloped Top Flange Open Top Flange Closed Top Flange Offset Top Flange Saddle Hanger Ridge Hanger Concealed Uplift Weldable Non-Backed Bevel Cut Butt Cut NOTE: No uplift loads are allowed for welded header attachments. 1. Available in 45 only. 2. JB/LB cannot be modified, use LBV. 3. Available in bevel cut or square cut joist. 4. HWU, WPU and WNPU cannot be skewed when the hanger width is greater than 3 ". 5. Slope and skew combination is for down slope only. 6. Refer to page 63 for loads. 7. For U and HU type hangers, bevel or square cut available up to 50 . Greater than 50 square cut required. 8.Available on double 2x and 4x models only (only with acute flange concealed). HEIGHT FOR SLOPED HANGERS: Height 1 (H1) is the joist height before the slope cut has been made. Net Height (Net H) is the joist height after the slope cut has been made. Provide H1 when ordering a connector. Connectors are made assuming dry lumber is being used in continuously dry conditions. Simpson Strong-Tie will calculate the Net H dimension based on the mathematical formula of H1/cos angle.

[close]