Page 192 of Wood Construction Connectors 2006 Catalog by Simpson Strong-Tie

193 Hanger Options HANGER OPTIONS See Hanger Options General Notes. INSTALLATION: Bevel-cut the carried beam for skewed hangers. HANGER HEIGHT For hangers exceeding the joist height by ", allowable load is 50% of the table roof load. SLOPED AND/OR SKEWED SEAT GLT/GLTV/HGLT/HGLTV and GLS/HGLS series may be skewed to a maximum of 50 or sloped to a maximum of 45 . For skews greater than 15 , multiply the table uplift load by 0.50. For sloped only, the maximum allowable load is 6500 lbs. for the GLT/GLS/GLTV, 9165 lbs. for the HGLT/HGLS/HGLTV. For skewed only, the maximum allowable load is 6550 lbs. for the GLT/GLS/GLTV, 7,980 lbs. for the HGLT/HGLS/HGLTV. The deflection at full loading may reach ". Sloped and skewed GLT/GLS/GLTV configurations have a maximum allowable load of 5500 lbs. Sloped and skewed combinations are not allowed for the HGLT/HGLS/HGLTV. SLOPED TOP FLANGE A top flange may be sloped down left or down right to 30 with or without a sloped and/or skewed seat (see illustration). Reduce allowable table loads using straight-line interpolation (see page 190). OFFSET TOP FLANGE The top flange may be offset left or right for placement at the end of a header. Minimum seat width 3 ". The maximum allowable load is 0.50 of the table roof load for the GLT/GLS/GLTV, and 0.45 for the HGLT/HGLS/HGLTV. For skewed and offset top flange hangers, the maximum allowable load is 3500 lbs. No uplift load. GLT/HGLT/GLS/HGLS/GLTV/HGLTV Typical GLT Top Flange Offset Left (HGLT similar) Typical HGLT Top Flange Sloped Down Left with Low Side Flush Typical GLT Sloped Down, Skewed Right When ordering, specify Low Side Flush, Center Flush or High Side Flush See Hanger Options General Notes. SKEWED SEAT GH hangers may be skewed to a maximum of 45 bevel cut required. The allowable loads are 100% of the table load. Specify GHD for saddle-style hangers. GHD may not be skewed. Typical GH Installation Skewed Right GHD GH Girder Hanger THGB/THGBH See Hanger Options General Notes. SLOPED OR SKEWED SEAT, 45 MAXIMUM The maximum allowable down load and uplift load for slope is .74 of the table load. The maximum allowable down load and uplift load for skew is .87 of the table load. Typical THGBH Installation Skewed Left THGBH3 (Skewed Left)

[close]