Page 405 of Walcott Cb sales catalog by Walcott Cb Sales Inc.

Catalogue PDF 08/2005 Firestik TTK1 Firestik II Tunable Tip Repair Kit FireStik Perform antenna repairs and/or replace old or lost parts with this item. The tunable tip repair kit for Firestik II antennas includes a 1/4"-20 x 1.25" brass tuning screw, a brass jam nut, a rubber o-ring and a new red plastic tip. 1.49 US Firestik AR4 Double Female UHF (PL259) Connector FireStik Use this connector to join two, PL-259 terminated coax cables together when additional length is required. If the back of your radio is hard to access, use a jumper (see our R-36A) from the radio and use one of the AR-4's to connect it to the antenna lead. When it becomes necessary to check or tune your antenna you seperate the two cables at the AR-4 connector and place your SWR meter in-line. 1.95 US Firestik AR5 Coax T Connector One Male Two Female FireStik The T-connector has a couple of main uses. First, if you want to run dual no-ground-plane antennas you add the T-connector to the back of the radio and connect the coax from the two antenna leads to the ends of the "T". Likewise, if you have a standard co-phase installation you can use individual runs of RG-59 A/U to each antenna instead of a pre-made co-phasing harness. 3.95 US Firestik AR6 Coax T Connector Three Female FireStik Standard 3-Way UHF T-Connector with female termination on all ends. Use to connect three PL-259 terminated coaxial cables to a central point. 2.95 US Firestik AR7 Coax Right Angle Adapter FireStik This connector is especially handy when the room behind the radio is limited and the use of the radios antenna connection places too much stress on the coaxial cable. Screws on to the antenna connection located on the back of the radio and accepts all coaxial cables that are terminated with standard PL-259 connectors. 2.95 US Page 405/525

[close]