be followed when removing automotive trim and moldings as well as other special ... , remove windshield wiper arms and trim necessary to expose the entire ... with a utility knife. Cut as close to edge as possible. 4. Cut out glass with ... windshield and car body. Slit tape at edge of glass. Remove windshield. 6. Remove ... off the pinchweld and exposing bare metal. NOTE: On urethane installations, it is ... fresh ure- thane. 7. Prime any bare metal scratches with 3M Black Primer, (Step 2 ... cleaning is required, prime pinchweld metal with a 2 part epoxy automotive paint ... . 11. Apply dam material to inside edge of pinchweld or 3M Foam Spacer Blocks, ... behind and contacting the dam material. 14. Position the glass by aligning the ... adhesive. 15. Paddle squeeze out around edge of glass if possible. If necessary, ...
off the pinchweld and exposing bare metal. NOTE: On urethane installations, it is ... from pinch- weld. 7. Prime any bare metal scratches with 3M Black Primer (Step 2 ... cleaning is required, prime pinchweld metal with a 2 part epoxy automotive paint ... the pinchweld or directly to the glass. 14. Position the glass by aligning the ... adhesive. 15. Paddle squeeze out around edge of glass if possible. If necessary, ... moldings, windshield wipers and other trim removed in Step 1. 18. Clean any ... remove windshield wiper arms and trim necessary to expose the entire ... a utility knife cutting as close to edge of the glass as possible. 4. Cut out ... windshield and car body. Slit tape at edge of glass. Remove windshield. 6. Remove ... off the pinchweld and exposing bare metal. NOTE: On urethane installations, it is ...