the facing. Also examine the quill of the transmission. There may have been ... the facing. Examine the input shaft of the transmission. Clean the shaft with ... For reinstallation, place a light film of white lithium grease on the input ... the disc facing. Look for evidence of engine and transmission misalignment. ... Misalignment can cause non-release of the clutch system. There are certain ... . Broken cushion segments on the clutch disc are also indications of ... mounts, warped bellhousing, damaged vehicle frame, or a flywheel that is wobbling ... alignment problems. Reinstallation of New Clutch Kit Once you are ready to ... reinstall the new clutch kit, the important issue becomes ... Greasy hands can easily contaminate a clutch disc. Grease on the disc will cause ...
the engine, or a possible misalignment of engine and transmission will occur. ... Install the bellhousing by placing all of the mounting bolts in by hand and ... avoid hanging the transmission on the clutch disc. In many cases the clutch job is ... transmission is allowed to hang on the clutch disc before the input shaft is in ... the pilot bearing, the result is, the clutch hub becomes bent and will now wobble ... on the input shaft. This will prevent a release. If a transmission jack is not available ... pins in the top mounting boltholes of the bellhousing. Place the transmission ... , do so slowly. Be sure the input shaft of the transmission slides easily through ... the I.D. of the clutch release bearing and that you do not knock the ... fork off of the ball stud. Install the mounting ...