PSL 750 psi 0.50 f. For face-mount hangers straight straps, use 0.86 of table ... to its grain. Take wood shrinkage into account when designing and installing ... -installation tightening. l. Top flange hangers may cause unevenness. Possible remedies ... and include using a face mount hanger, and routering the beam or cutting the ... . Contact factory for details. p. Hanger Options (page 188) some combinations of ... hanger options are not available. In some ... . Horizontal loads induced by sloped joists must be resisted by other members in ... in the tables, unless otherwise noted. Hanger configurations, height, and fastener ... may vary from the tables depending on joist size, skew and slope. See the allowable ... table load for the non-modified hanger, and adjust as indicated. Gauge may ...
Loads (133 160) 1 W1 W2 L1 L2 H1 H2 Beam Surface Post Surface Post Top Surface ... capacity. 3. Loads are for a continuous beam. 4.Spliced conditions must be detailed ... splice condition load is 6750 lbs per beam side and the lally cap must be evenly ... a 6x post. Double shear nailing between beam and post gives added strength! The BC ... achieved. BCS: install dome nails on beam; drive nails at an angle through the ... beam into the post below to achieve the table ... BC: install with 16d commons or 16dx2 joist hanger nails. Post bases do not ...