26, 27 Girder Hangers ... 62-67 SOLID SAWN CONNECTORS Adjustable Hangers ......................... .... 82, 83 ... Concealed Joist Tie ......................... ........ ... 186 Face Mount Hangers ......................... ... 68-76 ... Rough Lumber Face Mount Hangers ........ 76 Sloped/Skewed Connectors ... ................ 82, 86 Top Flange Hangers ......................... .... 77-81 ... COMPOSITE LUMBER CONNECTORS Adjustable Hangers ......................... 114, 115 ... Concealed Joist Tie ......................... ........ ... 186 Face Mount Hangers ......................... ... 90-96 ... 118 Sloped/Skewed Connectors ............ 114, 117 Top ... Flange Hangers ......................... .. 97-113 ... GLULAM BEAM CONNECTORS Concealed Joist Tie ......................... ........ ...
PSL 750 psi 0.50 f. For face-mount hangers straight straps, use 0.86 of table ... -installation tightening. l. Top flange hangers may cause unevenness. Possible remedies ... . Horizontal loads induced by sloped joists must be resisted by other members in ... may vary from the tables depending on joist size, skew and slope. See the allowable ... manufacturing process used. U and W hangers normally have single stirrups; ... . B, GLT, HGLT, HW, LBV, W and WNP hangers for sloped seat installations are ... seat. The customer must provide the H1 joist height before slope. r. Truss plates ... must be replaced. Refer to page 188 for hangers which can be welded. a. All specified ... allowable loads. Contact Simpson. h. Joist shall bear completely on the connector ... seat, and the gap between the joist end and the header shall not exceed per ...
