INFORMATION GENERAL NOTES a. Simpson Strong-Tie Co., Inc. reserves the right to change ... loads for Douglas Fir are the same as LVL, LSL, PSL, Glulams and Southern Pine, ... (HF) 405 psi 0.43 Glulam 560 psi 0.50 LVL (DF/SP) 750 psi 0.50 TimberStrand LSL ( ... PSL 750 psi 0.50 f. For face-mount hangers straight straps, use 0.86 of table ... loads for Spruce-Pine-Fir. g. Simpson Strong-Tie Co., Inc. will manufacture non-catalog ... -installation tightening. l. Top flange hangers may cause unevenness. Possible remedies ... manufacturing process used. U and W hangers normally have single stirrups; ... . B, GLT, HGLT, HW, LBV, W and WNP hangers for sloped seat installations are ... must be replaced. Refer to page 188 for hangers which can be welded. a. All specified ... as they may preload the holdown. j. Strong-Drive Screws shall not be installed through ...
shear is limiting. Glulam 145 psi, LVL 285 psi, LSL 285 psi, PSL 290 psi; E 1. ... 3x10 6 psi. f. Simpson strongly recommends the following addition to ... drawings and specifications: Simpson Strong-Tie connectors are specifically required ... set forth in this catalog. Simpson Strong-Tie Co., Inc. warrants catalog products to ... in material or manufacturing. Simpson Strong-Tie Co., Inc. products are further ... to environmental conditions. Simpson Strong-Tie connectors are designed to enable ... and high velocity winds. Other Simpson Strong-Tie products are designed to the load ... catalog. Properly-installed Simpson Strong-Tie products will perform in accordance ... catalog specifications and Simpson Strong-Tie connectors are properly installed in ... . All warranty obligations of Simpson Strong-Tie Co., Inc. shall be limited, at the ...
