3M Automotive Windshield Replacement Procedures These ... for urethane bonded automotive windshields using the full cut out procedure with ... setting height. 1. If necessary, remove windshield wiper arms and trim necessary to expose ... , make sure there is a MINI- MUM of 1/4 inch of glass, in addition to the space that ... location by apply- ing masking tape to windshield and car body. Slit tape at edge of ... glass. Remove windshield. 6. Remove major portion of old ure- ... allow to dry for at least 5 minutes. 8. Clean inside surface of glass with 3M ... , 08686, or 08692) over the primed 3/4 inch of glass. Allow primer to dry for at ... and height. A height of 1/2 to 9/16-inch and a 1/4 - 5/16-inch base is suggested ... . 13. Apply 3M Auto Glass Urethane Windshield Adhesive - MV directly onto the ...
allow to dry for at least 5 minutes. 8. Clean inside surface of glass with 3M ... 08683, 08685 or 08691) to the outer 3/4 inch of the glass with a clean wipe. Wipe ... , 08686, or 08692) over the primed 3/4 inch of glass. Allow primer to dry for for ... to give good contact with the windshield around the entire perimeter. A ... bead shape and height. A height of 1/2 inch to 9/16-inch and a 1/4 inch- 5/16- inch ... . 13. Apply 3M Auto Glass Urethane Windshield Adhesive High Viscosity, or 3M Fast ... alignment strips. 17. Replace moldings, windshield wipers and other trim removed in Step ... for urethane bonded automotive windshields using the full cut out procedure using ... -Part Urethane. 1. If necessary remove windshield wiper arms and trim necessary to expose ...